Contents
How do I reset my ScreenLogic password?
You will need to access Screenlogic from your computer that is on your network, on a local connection, you will not need your password at this point and open up configure screenlogic from your home screen and click on configure S/L again and go to set 1 of 5 to reset your password, if you are experiencing and other …
How do I update my Pentair firmware?
Once you have a good connection, press “Install Update” in your Pentair Link2O™ Technology App to install the Wireless Technology Firmware Update. Once the update begins, a screen will appear that says, “Device Updating!” Do not disconnect power from your IntelliConnect during this installation process.
How do I change my Pentair ScreenLogic password?
Once you click on “Configure Screenlogic” on the first screen, you’ll click the larger “Configure Screenlogic” on the second screen. On the “General Settings (1 of 5)” page there is a button near the bottom of that page “Set Remote Access Password”. Click that and set your password.
How do I reset Pentair screenlogic wireless router?
Cycle the power to both of these devices.You can use a paper clip to reset the Protocol Adapter by pressing the recessed reset button. You canunplug and plug back in the wireless router to reset it. 3. Verify the wiring to the protocol adapter and IntelliTouch Load Center.
What should I do if my Pentair screenlogic is not working?
Direct connect your protocol adapter to the ET panel and your network router or switch via hardwire. Get a 4 conductor cable 18-22 awg and use it. Remove the wireless link from the picture. If that works you know your protocol adapter is good and the wireless link is bad.
What to do if your Pentair adapter goes bad?
Go into your router settings program and see if the Pentair protocol adapter is showing as active or inactive. If shown as inactive, and you have rebooted everything then your Protocol adapter has died. I have had two adapters go bad with similar symptoms as yours.
What to do if your screenlogic2 is not working?
If ScreenLogic2has been previously working without a problem, try the following steps to resolve the problem: 1. Make sure your wireless ScreenLogic2 device is connected to your wireless router. In most cases, theeasiest way to re-establish a connection is to perform a cold boot of the ScreenLogic2 device: a.