Contents
How do I program my Viper remote start remote?
Use the vehicle key in the ignition and turn it to the on position. Find the antennae button. Press and release the button, then hold it. Press lock when ready to begin pairing.
How do I reset my Viper remote start?
Way 1
- As the alarm starts to ring, hold your viper remote in your hand and point the fob key towards your car.
- Hold for 10 seconds. Then press the lock button on your key. Now your alarm has been reset.
Why does my Viper remote start not work?
If the procedure mentioned above does not work simply turn the key off then back on and press the valet switch two times. If this does not work turn the key off then back on and try it three times. Continue this up to five and one of them should disarm the alarm.
What does the F mean on Viper remote?
Your remote will now automatically lock 60 seconds after your last command is sent. To unlock the remote before each use simply press “F” then the unlock button.
Why is my Viper remote not working?
Remote Not Paired Start by replacing the batteries in your remote to rule out a dead battery, but if you still get no response then you might try re-pairing your remote. Since there are different pairing procedures for different Viper remotes, I can’t give you a universal procedure to follow.
How do you reset a remote start?
Press the Lock button on your remote car starter. Within five seconds of turning it on, turn your key back to the “off” position (or press the start button again). Repeat the on-off cycle three more times—you’ll do four in total.
How to program a new Viper car remote?
How do I program my new Viper remote? 1 Place your key in your car’s ignition and turn the key to the “On” position. 2 Press and hold the ” Program ” switch on your car’s alarm transmitter. 3 Press any button on your car remote while you are holding the ” Program ” switch and release both buttons.
How do I disable my Viper car alarm?
How to Disable a Viper Car Alarm Press and hold the “Arm” button on your remote until the alarm turns off wirelessly. Open your car door, and use the “remote valet” method to stop the alarm.
Programming your remote may be slightly different depending on which system you have. To pair your remote, you have to locate the Valet control button which is located on the windshield above the review mirror on most vehicles, but may be located in someplace else on your car.