Contents
How do I set my Lorell Radio Controlled Clock?
Manual Time Setting: Hold the SET button on the back of the movement for 3+ seconds to activate manual mode. 2. Once the clock is in manual mode press the “SET” button to adjust time. Press and release immediately to advance one minute, press and hold and hands will rapid advance.
How do you reset a radio controlled wall clock?
Radio-Controlled (MSF) Clock
- Insert a new AA battery.
- Press Reset button at the back of the clock, the clock hands will go clockwise and it will automatically set itself to the correct local time.
Why is my radio controlled clock wrong?
Check that the power supply is in full working order. Change the current battery for a fresh one and reset your clock. Try rotating the clock. Most radio-controlled clocks have an internal antenna that picks up the signal most effectively when it is facing directly towards or away from Anthorn.
Why is my radio controlled clock not working?
What does rec mean on radio Controlled clock?
Receive Button
MANUAL TIME SIGNAL SEARCH While the clock is running, press and hold the Receive Button (REC) for at least 3 seconds.
How to set your analog radio controlled clock?
Set the clock in radio search mode showing 12:00 – Step 3 (crucial step do it carefully) Slowly and gently move with your fingers the pointers , (do it that way in order to avoid moving the internal gears) , the amount of time that the radio clock needs , in order to show the correct time .
How do you set an atomic clock manually?
Atomic Clocks may also be set manually and be very accurate. Simply insert the battery, press your time zone and then press the flap just above the left side of the battery. Hold until you reach the correct time and then release. Your clock is now an accurate quartz clock until it will find the signal.
How does a Staiger radio controlled clock work?
Simply insert the battery, press your time zone and then press the flap just above the left side of the battery. Hold until you reach the correct time and then release. Your clock is now an accurate quartz clock until it will find the signal. Your Atomic clock will still continue to look for the signal and start adjusting itself automatically.
How to force clock to search for radio signal?
TO FORCE CLOCK TO SEARCH FOR RADIO SIGNAL: · During normal run time, press the REC button for 3 seconds. The hands stop moving and the clock starts searching for the radio signal. (There are 2 REC buttons on the back of your clock and you may use either one.) · If reception is successful, the hands synchronize to the correct time.