Contents
Where is the blower wheel on a dryer?
The blower wheel is attached to the drive motor shaft. It spins to blow air throughout the drum and out the exhaust vent. If air isn’t moving through the dryer, or if the blower wheel rattles, replace it with a manufacturer-approved dryer part.
Where is the blower wheel on my dryer?
Can a dryer blower get clogged?
A clogged blower wheel is commonly the culprit behind a noisy dryer. Check your lint filter. If the filter is clogged, then lint may be hindering your blower wheel, so cleaning it out could solve the noise issue.
How do you remove the front of a Samsung dryer?
Lift the control panel away from the front of the Samsung dryer and set it on top of the dryer cabin, out of the way of the front panel. Remove the two screws at either of the upper-front corners of the front panel with the screwdriver. Open the dryer’s door and remove the two lint filter screws at the bottom edge of the dryer’s door opening.
How do you replace the front of a blower dryer?
Disconnect the wire harness. Use a 5/16-inch nut driver to remove the front panel mounting screws from the inside of the cabinet. Pull the front panel forward slightly, and then lift and unhook it from the 2 bottom hangers. Pull the front panel off of the dryer and set it aside.
How do you remove a wheel from a blower dryer?
Use a Phillips screwdriver to remove the 2 screws that secure the lint screen housing to the top panel. To release the clips that lock the top of the dryer in place, push a putty knife under the lid near the left and right edges of the front of the dryer.
How to disassemble an LG dryer to remove a sock?
How to disassemble an LG dryer to remove a sock or something stuck in the blower. At each plastic “hinge”—there are 2 phillips-type screws—remove only the lower screws at each “hinge”. Grasp the TOP COVER and slide rear about 2 inches—lift off & remove. Standing at the front of the dryer—remove the WATER DISPENSER TRAY…