Contents
How do you remove Stanley toolbox drawers?
Most Stanley toolboxes use small hand-operated levers on either side of the drawer. Extend the drawer as far as it will go, then push the levers on each side in opposite directions. This releases the drawer so you can pull it out the rest of the way.
What is Craftsman Quiet Glide?
Quiet Glide™ drawer slides provide smooth, quiet drawer operation and hold up to 50 lbs. per drawer. Upgrade to ball-bearing drawer slides with the 009-13621 top chest. Drawer dimensions: 5 drawers measure 22 3/8″ W x 10 3/4″ D x 2″ H.
How do you open a snap box without the key?
Proper tools are needed and it should only be done when you are the legal owner of the box.
- Pry the top drawer of the toolbox down slightly with a crowbar.
- Slide a long, thin piece of metal into the opening made by the crowbar.
- Jimmy the metal piece so it shifts under the lock bar in the back of the box.
How do you remove a drawer from a craftsman tool chest?
Pull the drawer out of the cabinet. Press the tabs on each side with your fingers, if your drawer uses tabs instead of levers. Pull the drawer completely out of the tool chest. Kenneth Crawford is a freelance writer with more than 10 years of experience.
What to do if your Craftsman Tool Box is stuck?
For some reason, the drawer of your Craftsman tool box has gotten stuck in the middle. Maybe the drawer is not opening all the way, or it is stuck in one place. First, try not to pull the drawer harder. It could worsen the situation. Use a flashlight and observe the side slides to locate the item or part that is causing it to be stuck.
How do you remove a tool box drawer?
Then, you take your thin piece of metal and you push this in a couple of inches till you’re past this part. Then, you pull the drawer and it will come past the catch. It is free now. Now, the other side is still attached, so I can’t take the drawer all the way out.
How do you take a drawer out of a cabinet?
Look on the side rail to see if you have a lever or tabs. If you have levers, pull each lever up or down, depending upon its current position. Pull the drawer out of the cabinet. Press the tabs on each side with your fingers, if your drawer uses tabs instead of levers. Pull the drawer completely out of the tool chest.