How many LED lights can I put on a dimmer switch?

How many LED lights can I put on a dimmer switch?

As an example – if you have a dimmer switch with a maximum rating of 400W (rule of thumb translates to 40W) you can run five 7.1W dimmable LED light bulbs (see example below for further explanation).

Can a dimmer damage LED lights?

The simple answer is yes – there can be a fundamental incompatibility between the LED driver and the dimmer which leads to spurious and often very large current pulses into the driver. Oscillogram 1 shows the measured LED voltage (red) and current (yellow) of a GU10 LED lamp being dimmed with an incompatible dimmer.

Can you dim LED lights from two locations?

Traditionally, you cannot dim a light from two different switches, as it will cause a conflict in the circuitry. Any electrician will tell you that this will not work for a regular double switch three-way circuit. A master and slave switch controls the dimmers in multiple locations around your house.

Do LED lights have a limit?

The answer: generally, yes, it is safe as long as the actual wattage of the LED bulb is within the limits of the socket or fixture. This means that they consume just a fraction of energy (actual wattage) to provide the same amount of light output (equivalent wattage).

Can you have 2 dimmers on the same circuit?

You can only have one dimmer per group. You can put the dimmer at either location, but not both locations. There are “companion” dimmers available from some companies, that allow you to place additional dimmers in the circuit.

Can I use a 3 way dimmer switch as a single pole?

In order for a 3-way switch to function as a single pole, the wires need to be connected to the common and one of the traveler terminals. It will not work if the wires are connected to the two traveler terminals. 3-way switches can be converted to single pole in several configurations.

How big of a dimmer do I need for a LED light fixture?

Make sure that the LED bulb you use doesn’t have a wattage that is higher than what is specified for the fixture. Basically, most dimmers are designed to accommodate the load of 600 watts. There are also heavy-duty dimmers that can handle 1000 to 1500 watts.

Can a LED light bulb be used with a dimmer switch?

The bottom line is compatibility. Some LED bulbs are designed for use with standard dimmer switches, while others are not. Some fixtures, such as under cabinet and recessed lights, may need special LED dimmer switches for proper performance. LED light bulbs are increasing in popularity.

How many LED bulbs can a Lutron dimmer handle?

Lutron C.L Dimmers can control up to 17 bulbs and is the only dimmer UL listed to control mixed loads (different types of bulbs, such as LEDs and halogens, on the same circuit). To learn the actual load requirements for a particular dimmer and fixture, testing must be done.

Can a dimmer be used on an incandescent light?

The dimmers installed for older incandescent light sources work with forward phase control technology. These are primarily suitable for resistive loads. However, LED lamps represent a capacitive load. The old dimmers are therefore mostly unsuitable for the new LED lamps. Most LED lamps require a reverse phase control dimmer.