Contents
How do you change Braun Fahrenheit to Celsius?
Answer: Apparently, you can switch back and forth between Celsius and Fahrenheit. Press start button for 8 seconds until it switches between the two settings. Your Braun ThermoScan is delivered to you with the Celsius (°C) temperature scale activated.
What does Lo mean on a digital thermometer?
LOW TEMPERATURE
It is standard practice for the majority of digital thermometers to display a “LO” sign when turning the device on. This means “LOW TEMPERATURE”. This is because these types of thermometers are made to measure Body Temperature, so when outside the body, the temperature is usually LOWER.
How do I fix my Braun thermometer?
Make sure the probe tip and lens are clean and a new, clean lens filter is attached. Make sure the thermometer is properly inserted. Then, take a new tem- perature. If error persists, If error still persists, Wait 1 minute until the thermometer turns off automatically, then turn on again.
Why does my Braun thermometer say error?
When ambient temperature is too high or too low to take an accurate reading, device will provide an “Err” message with flashing up/down arrow icon. The error message will appear after start up and memory recall.
Are Braun thermometers accurate?
Temperature can be taken in the ear, mouth, bottom, under the arm or on the forehead. Each method is considered accurate when done correctly. Not only this, but a recent study concluded that, when used in newborns; Braun ThermoScan® 7 offers the same accuracy as the study’s comparative rectal measurement readings.
How do I set my digital thermometer to Lo?
The ‘Lo’ or ‘Hi’ indications on the display mean that the temperature cannot be measured because the temperature is outside the temperature range. Press the on/off button to switch off the thermometer. Check if it is correctly positioned, press the on/off button again to switch it on, and re-start the measurement.
How do I fix my digital thermometer?
Fill a glass with crushed ice. Add a little clean water until the glass is full and stir. Wait for about three minutes before inserting the sensor on the thermometer into the ice-filled water. Wait for about thirty seconds and check that the thermometer reads 32°F.
How do you calibrate a thermometer?
Put the thermometer stem or probe into the ice water. Make sure the sensing area is under water. Wait 30 seconds or until the reading stays steady. Adjust the thermometer so it reads 32˚F (0˚C).
What does PO5 mean on Braun thermometer?
What does po5 mean on Braun thermometer? The code is POS which means “If the probe has not been constantly placed in a stable position in the ear canal, a sequence of short beeps will sound, the exac temp light will go out and the display will show a error message POS=position error.”
What does Pos mean on a thermometer?
POS mean “Position Error” in ThermoScan. If it isn`t positioned in right place, a sequence of short beeps will sound then in will show the error message POS. You download the manual to this link http://personalcare.manualsonline.com/manuals/mfg/braun/6022_6023.html?idRes=3619877. Was this answer helpful? Yes | No
What does Green exactemp light on Braun thermometer mean?
The thermometer will beep once. The green ExacTemp light above the Start Button flashes, indicating correct probe placement. 4. A long beep and a solid green ExacTemp light signals the end of an accurate measurement. Eject the used probe cover. For the next measurement, put on a new, clean probe cover. 6.
What happens when you remove the thermometer from the case?
Remove the thermometer from the case and attach a new probe cover. The device turns on automatically. 1. 5. If the probe is placed incorrectly or was moved while taking a temperature, the device beeps, the green ExacTemp light goes out and POS (Position Error) displays. 98.4 97.8 99.1 94.1 2.