Contents
When was wire lath used?
Metal lath dates from the late 19th century and is used extensively today with plaster and stucco in home and commercial construction.
When did they start using lath and plaster?
From the 1700s all the way through the 1940s, lath and plaster was the interior wall construction method of choice. Builders nailed thin, closely spaced strips of wood (lath) to wall studs and then smoothed multiple coatings of plaster over the lath to form flat wall surfaces.
What is metal lath?
Metal lath provides a lightweight and easily attachable base for plaster application. Made from expanded steel, the lath generally is applied flat across the stud plane and attached with staples, nails, or wafer head lath screws.
How old is lath and plaster?
What is lath and plaster? The lath and plaster technique was generally used to finish interior walls and ceilings from the 1700s to the early-to-mid 1900s before it was superseded by modern gypsum plaster and plasterboard.
What are metal lath used for?
Metal lath is used to prevent or decrease wall crackings in either pumped or troweled application. Sheet metal lath is slit and expanded into small diamond openings (approximately 11,000 per square yard).
Do all plaster walls have lath?
Lath and plaster If your home was built before 1950, you most likely have traditional lath-and-plaster walls. The plaster that oozes between the lath strips is called the key, which locks the plaster and lath strips together.
How thick is a metal lath?
Thickness – The nominal thickness of diamond mesh and flat rib metal lath shall be 1⁄8 in. (3.2 mm). The nominal thickness of other rib metal lath shall be as designated, 3⁄8 in. (9.6 mm).
Can you drywall over lath?
You can attach drywall directly to lath. If you’re remodeling an older home and you run into a plaster-and-lath wall, you can remove the plaster and install drywall over the laths. After securing the laths, you’ll install the panels in the same way you would install them on a new stud wall.
Can you skim over lath plaster walls?
Lath & plaster when it starts to come away in my experience it is advisable to re board and skim. This then reinforces the integrity of the ceiling.