Menu Close

Can a radon fan be installed inside?

Jim Brown

Can a radon fan be installed inside?

If it’s indoors, the fan must be located in an unfinished attic. Never install the fan in your basement or any living space because, if there’s ever a leak, the fan could pump highly concentrated radon right into your home.

How do you install a radon mitigation system in a basement?

Steps for Installing Radon Mitigation

  1. Step 1: Make a hole.
  2. Step 2: Dig out under the slab.
  3. Step 3: Run pipe from cellar to attic.
  4. Step 4: Place and seal pipe.
  5. Step 5: Run the pipe to a fan.
  6. Step 6: Install a manometer.
  7. Step 7: Test the system.

How much does it cost to install a radon fan?

The radon fans are guaranteed by manufacturers for 3 – 5 years. Their replacement cost, including installation, is usually $300 to $600. Homeowners are aware that the fan must run continuously 24/7, year after year. The typical estimate of the electricity cost is $150 per year.

How do I reduce radon in my basement?

An effective method to reduce radon levels in crawlspace homes involves covering the earth floor with a high-density plastic sheet. A vent pipe and fan are used to draw the radon from under the sheet and vent it to the outdoors.

Can radon fan be too powerful?

Radon fans are powerful, typically moving 100 too 250 cubic feet of air per minute; any break in the pipe or loose fitting or at worst a disconnected vent pipe would blow out high concentrations of radon into the home.

How do you install a Radon fan in the basement?

In the basement, install the system monitor that will ensure that the radon fan is functioning well. Using the drill, drill a hole in the basement that should be at least 1 inch in diameter. Turn on the fan and using the smoke pencil, check the fan’s draw. Your radon fan is now installed and ready to work!

Where to install a radon mitigation system in a finished home?

The technician will try their best to make sure the fan is towards the back of the house, however, the initial access point in the basement will determine where the pipe and fan need to exit the home.

Where is the best place to place a Radon fan?

So garages, attics and on the outside of the house are the only acceptable locations for fan placement. Basements and crawlspaces are considered part of the conditioned air space of the home thus not allowed. I have seen many cases of homeowners who have disregarded the fan location standards and had to reinstall it when the house is sold.

What should the radon level of a ceiling fan be?

If you have a radon level of around 4pCi/L the level of radon being pushed out of the exhaust side of the fan can be many times higher, even into the 100s of pCi/L. So if a leak was ever to occur above the fan your radon level could rise even higher than before the radon mitigation system was installed.

Can a radon fan be installed inside?

Jim Brown

Can a radon fan be installed inside?

If it’s indoors, the fan must be located in an unfinished attic. Never install the fan in your basement or any living space because, if there’s ever a leak, the fan could pump highly concentrated radon right into your home.

How do you install a radon mitigation system in a basement?

Steps for Installing Radon Mitigation

  1. Step 1: Make a hole.
  2. Step 2: Dig out under the slab.
  3. Step 3: Run pipe from cellar to attic.
  4. Step 4: Place and seal pipe.
  5. Step 5: Run the pipe to a fan.
  6. Step 6: Install a manometer.
  7. Step 7: Test the system.

Can a radon fan be installed horizontally?

Radon Fans Have to be Mounted Vertically. Piping on the outside also needs to be vertical on a Radon system. A foot or two or horizontal piping is OK if really needed, but for the most part, it should go vertically up the side of the home.

Will opening basement windows reduce radon?

Opening windows improves air circulation and ventilation, helping move radon out of the house and mixing radon-free outside air with indoor air. Opening basement windows helps reduce negative air pressure, diluting radon with clean outdoor air.

Why is the basement not a proper radon fan location?

Why is the basement not a proper radon fan location? The purpose of a radon fan is to draw radon from out of the soil below the home and release it safety above the house. If you have a radon level of around 4pCi/L the level of radon being pushed out of the exhaust side of the fan can be many times higher, even into the 100s of pCi/L.

Where to install a radon mitigation system in a finished home?

The technician will try their best to make sure the fan is towards the back of the house, however, the initial access point in the basement will determine where the pipe and fan need to exit the home.

Where is the best place to place a Radon fan?

So garages, attics and on the outside of the house are the only acceptable locations for fan placement. Basements and crawlspaces are considered part of the conditioned air space of the home thus not allowed. I have seen many cases of homeowners who have disregarded the fan location standards and had to reinstall it when the house is sold.

What is the purpose of a Radon fan?

The purpose of a radon fan is to draw radon from out of the soil below the home and release it safety above the house. If you have a radon level of around 4pCi/L the level of radon being pushed out of the exhaust side of the fan can be many times higher, even into the 100s of pCi/L.