Contents
Can I change a gas valve myself?
Although it’s perfectly fine to fit a new gas valve yourself, if you don’t get it right it can be dangerous. This is because the gas valve regulates the pressure of gas that the furnace is getting, preventing fires and explosions. The gas valve also prevents gas from leaking out of the furnace.
Do plumbers hook up gas dryers?
Gas dryers are best installed by professional plumbers. Although a lot of internet articles say it’s a DIY task, a plumber’s experience is a just price to pay in exchange for safety. A licensed plumber can identify the correct fitting for your new piping installation.
How does a gas valve on a dryer work?
A gas dryer blows air through a burner assembly to heat the air. On the gas valve are one or two coils (solenoids) used to open and close the valve to control the flow of gas. If a coil fails, gas will not flow and the dryer will have no heat.
Is it safe to turn off gas to dryer?
It is important to be very cautious when disconnecting your dryer from the gas line because of potential fire hazards or gas explosions. If you feel at all hesitant about disconnecting your gas dryer yourself, make sure to contact a qualified technician to perform the task for you.
How do you install a gas valve on a dryer?
Line up the mounting holes and reinstall the screws in the top of the front panel to secure it to the dryer cabinet. Plug the wire harness back into the plug on the door switch. Make sure the locking tab engages properly. 07. Lower the top panel and snap it into place.
What happens when you close the gas valve on a clothes dryer?
All coils are now energized and gas flows past the still hot igniter and bursts into a blue flame. The flame will radiate enough heat to keep the radiant sensor open. Power is removed from the burner assembly when the operating thermostat opens up. The gas valves close, the flame goes out and the radiant sensor closes.
How do you replace the coil on a gas dryer?
This video explains how to replace the gas valve coil kit in a gas dryer. 01. Unplug the dryer to disconnect electrical power. Shut off the gas supply to the dryer. Wear work gloves to protect your hands. 02. Pull the lint screen out of the housing in the top panel of the dryer.
What kind of valve is in a whirlpool dryer?
The gas valve assembly contains a pressure regulator and two gas valves. The following figure shows an older style “K” series gas valve assembly for Whirlpool manufactured dryers but the same design is common on many brands.