Contents
Can you remove bathtub drain cover?
In either case, the only way to remove these types of covers is to pry them loose. You can either put a screwdriver in one of the holes of the cover and pry upward, or you can use a flathead screwdriver to pry up the outer edges.
What tool do you use to remove a tub drain?
Pliers: Short of a plug wrench, the best substitute is a set of needle-nose locking pliers. The pliers need to be small enough to reach into the drain and through the cross. Once the locking pliers are secured, you use a pair of standard pliers to turn the locking-pliers and loosen the drain.
How do I remove the drain stopper from my Kohler bathtub?
Lift and Turn Tub Stopper With the stopper in the open position, use one hand to hold the body of the stopper in place. Slowing turn the knob counter-clockwise, looking for a screw set on the knob. If there isn’t one, turn the stopper counter-clockwise to unthread from the strainer until it can be removed.
Why won’t my tub drain stay open?
When the tub isn’t draining properly, it’s because the linkage is too long. To shorten it, you need to take it out of the tub. Remove the overflow cover from the front of the tub by unscrewing the screws holding it in place with a screwdriver. Fit the cover back onto the opening and replace the screws.
How does a lift and turn drain work?
A lift-and-turn drain stopper is identified by a small knob on the cap of the drain stopper, which is used to twist the stopper open and closed. A lift-and-turn stopper is closed by turning the knob on the top of the stopper until it goes down, and it is opened by lifting and turning the knob in the opposite direction.
How do you take drain stopper out of tub?
Pop out a lift-and-turn drain’s stopper. Grasp the stopper and pull up on it. You should see a setscrew underneath the stopper’s cap. Use your screwdriver to remove this, and the stopper should then come out.
What should I use to unclog my Jacuzzi tub?
Unclogging your Jacuzzi tub can take some time, but few materials are required. Put on a pair of rubber cleaning gloves. Unscrew the Jacuzzi drain and remove it, if possible. Drop three tablets of Alka-Seltzer into the drain, then pour in 1 cup of white vinegar. Let it sit for about 15 minutes.
How do you take a foot plug out of a tub?
Put on your rubber gloves and grasp the center stopper. Turn it counterclockwise while pulling up slightly. After enough turns, the stopper should unscrew fully from the drain. Foot plug drains will have a stopper in the center of the drain that moves up and down when the tub is stopped. Pop out a lift-and-turn drain’s stopper.
How do you remove a lift and turn drain?
To take out a lift-and-turn drain stopper, grasp the stopper and pull up on it. Once you pull the cap off, use a screwdriver to remove the setscrew underneath. If you need to remove the faceplate of a trip lever drain, first set the tub to the “open” position. Then, use a screwdriver to remove any screws that are on the drain’s faceplate.