Contents
Can you use a zipper foot for piping?
The Zipper Foot can be used for inserting zippers as well as making and inserting piping or cording. The zipper Foot allows the needle to stitch close to a raised edge such as the teeth of a zipper or the thickness of cording.
What kind of fabric should I use for a bench cushion?
Cotton canvas is a great fabric to use for both indoor and outdoor cushions. It is strong, resilient, and also resistant to weather damage. Waterproof outdoor fabrics, like Sunbrella, are available to buy by the yard.
How do you make a Velcro bench cushion cover?
Place one side of the Velcro on the outer side of the bottom flap, near the seam and place the other piece of Velcro on the backside of the top flap, near the hemmed edge. Repeat as needed depending on the length of your cushion cover. Carefully remove the foam and sew the Velcro onto the fabric.
How do you make a bench cushion with piping?
1. Lay the top panel right side up on top of the cushion. Pin the piping on top of the fabric. Line up the piping with the edges of the cushion. Be sure the raw edge of your piping is facing the raw edge of the fabric.
How to make a bench cover out of fabric?
Lay out your fabric (err, I mean, shower curtain) folded in half. Place your cushion on top. Trace around the cushion about 3/4″ wider on all sides. Cut through the two layers. This will give you the top and bottom panels for your cover. 2. Next cut out four strips of fabric for the sides. Cut your lengths 2″ longer than your cushion.
What’s the best way to make a cushion cover?
Place the second cushion back piece over the first cushion back piece and the cushion front piece, right sides together. Match the raw edges and ensure the right sides are together. Pin in place. Sew along the edge, using a 1cm (0.4in) seam allowance. Trim the four corners of the cushion and turn right side out. And you’re finished. Well done!
How do you line a bench with piping?
Pin the piping on top of the fabric. Line up the piping with the edges of the cushion. Be sure the raw edge of your piping is facing the raw edge of the fabric. When you reach a corner, snip into the raw edge of the piping all the way (but not through) the rope piping.