How do I fix F1 error on Whirlpool Cabrio?
When the Whirlpool Cabrio displays an F1 error, this means the the control board is having difficulty communicating with the motor. To fix your F1 error, you can first try to unplug your washing machine for 15 minutes and then plug it back in. If this doesn’t work, you will need to replace the control board.
What does F1 mean on washer?
The F1 code indicates that the control board is defective. Try to reset the control board by unplugging the washer for 5 minutes. Plug it back in.
Why does my Cabrio washer say F?
The single F error without additional letters, signs, or numbers indicates the failure of the control board. It cannot send messages to other units and systems. This error is caused by voltage drops in the home network, severe voltage surges, and short circuits.
What is E1 error in Whirlpool washing machine?
E1 – water inlet alarm Clean the inlet hose filter screens. Be careful not to remove or disturb the screen placement. Check that the drain hose is not below 27½” (700 mm) from the floor.
What does F01 mean?
failed electronic machine control board
The F01 indicates a failed electronic machine control board. This error code can sometimes be caused by a glitch or power surge through the electrical lines.
What does F1 mean on a whirlpool Cabrio washer?
Error Code F1 or E2. These error codes indicates a failure in the main control of the motor control circuit. Here’s what you should do: The first step you should take is unplug the washing machine for at least 5 minutes. Plug it back in and see if the board was reset.
How to fix Whirlpool Cabrio dryer F01 error appliance?
If the dryer continues to give you the same error then the only way to fix it is to replace the control board. There are currently no recalls or a whirlpool cabrio control board recall for this error. Unplug or disconnect power the dryer. Remove the two screws at the rear of the console assembly.
Why does my Whirlpool Cabrio washer not turn on?
User presses START with the lid open. User presses START after two consecutive machine cycles without opening lid. The machine/motor control cannot detect the lid switch opening and closing properly. Po flashes when the drain pump begins pumping out water from tub because the door lid is left open for more than 10 minutes.
What to do if your Cabrio dryer says F1?
The F1 error on the cabrio dryer is the same as the F01 Error. First thing you will want to do is a simple cabrio dryer control board reset, which is done by unplugging the dryer for five minutes then plugging it back in. That will reset the board and put it back in standby mode.