Contents
How do I get my cruise control to work?
To use Cruise Control, turn it on first by pressing the button on the end of the control stalk behind the lower right side of the steering wheel. The green cruise control icon will appear in the instrument display to show the system is ready. Then accelerate to the speed you want, and press the stalk down to set it.
How do I reset my cruise control?
The cruise control system will be reset to the speed you are travelling when you release the knob. For a quick reset, accelerate with the accelerator pedal to the desired speed, then press and release the “SET/COAST” button.
Why would Adaptive cruise control stop working?
Classic cruise control systems work a bit differently, but, if your car is equipped with Adaptive Cruise Control, it could stop working due to a bad sensor or camera. The car can then slow down or accelerate automatically to maintain a set following distance from the vehicle ahead of you.
How do I know if my cruise control module is bad?
Symptoms of a Bad or Failing Cruise Control Vacuum Bleed Switch
- Cruise control does not disengage when pedal is pressed.
- Cruise control disengages on its own intermittently.
- Hissing noise coming from under the dash.
Where is my cruise control fuse?
The cruise control fuse is normally found in the fuse panel located below the steering wheel. Remove the cover of the fuse panel and locate the fuse for the cruise control using the fuse diagram on the fuse panel.
Is cruise control connected to a fuse?
Bad Fuse: Like many electronically controlled systems in your car, the cruise control has a corresponding fuse which will blow to protect the system if it senses a short circuit.
Where is the fuse for cruise control?
Why is the cruise control on my car not working?
Common Causes of Cruise Control Not Working. 1) Cruise Control Switch; 2) Brake Light Switch; 3) Blown Fuse; 4) Check Engine Warning Light; 5) Vehicle Speed Sensor; 6) Electrical Issues
Can a brake light disengage cruise control?
Brake Light Switch – As cruise control is automatically cancelled by depressing the brake, some vehicles may disengage cruise control if it cannot detect the brake light switch. Brake Lights – In some systems, cruise control is disabled when a brake light is blown.
Why does my cruise control drop out of engagement?
Does your cruise control fall out of engagement partway up steep hills? Actually, it will normally drop out if the engine has to work too hard, mainly because after a while there isn’t enough vacuum left to pull in the servo after sustained near-wide-open-throttle. You’ll just have to put your foot into it.
Can a check engine light cause a cruise to not work?
If your Check Engine light is on, the cruise may not work, especially if the VSS is malfunctioning. Older vehicles may use speed information from the speedometer.