Contents
How do I know if my pulley is bad on my riding mower?
If a pulley is badly worn, it can cause a bad vibration from the cutting deck on your lawn tractor. To check all your pulleys, start by removing the mower deck. Next, remove the mandrel covers and belt, then check all the pulleys for play and roughness when spinning.
Can you replace the pulleys on riding mower deck?
If you look at the mower deck on your lawn mower, you will see several pulleys mounted to the top. When this happens, you must pull the pulley off the spindle so you can replace the bearing.
Can you pulley swap a hydrostatic mower?
You can make your hydrostatic tranny go faster by installing a bigger pulley. If you get it right, the speed could surge spectacularly. Likewise, a pulley swap on hydrostatic lawn mower -another prospective option- can help but is similarly tricky.
Why is my lawn mower belt smoking?
The smell of the smoke is that of rubber burning from the belt just not sure what is causing it. If the belt is actually smoking then something is causing it to slip or rubbing on it. Wear on the outer flat side of the belt indicates a problem with an idler pulley.
How do you remove a key from a pulley?
Tap on the face of the pulley to nudge it away from the taper while you try this . The normal way to remove the key is to use a small cold chisel to impact the edge of the key in order to force it from its slot in the shaft.
Do you need to remove pulleys from riding mower?
This process varies greatly depending on the model and the brand of lawn tractor you own. In most cases, you will see rods that hold the deck to the underside of the lawn tractor. You must remove the rods to lower the deck to the ground. You need access to attach the spindle puller to the top of the pulley.
How do you replace drive belt on riding mower?
Cool the mower engine before starting the replacement. Press the lift lever attached to the mower deck and lower the deck at its lowest position. Use the screwdriver to remove the screws attached to the belt guard. You will find the guard near the grass discharge chute.
Can you replace the pulley on a Briggs and Stratton lawn mower?
This video provides step-by-step instructions for replacing the rewind spring and pulley on Briggs and Stratton small engines that are found in lawn mowers, riding tractors, zero-turn radius mowers, edgers, pressure washers, and generators produced by Toro, John Deere, Lawn Boy, and Craftsman.
Where are the idler pulleys on a riding mower?
You will find the idler pulleys near the middle of the deck and the idler pulleys are smaller in size than the regular pulleys used in the mower. If you have a 42-inch mower deck, this step is only for you. If you have different sizes of the deck then skip the 6th step. Notice how the belt is fastened around the pulley.