Contents
How do I reset my gatehouse door lock?
How to Reset a Gatehouse Electronic Lock to Its Factory Settings
- Remove the interior assembly cover to access the batteries.
- Remove one battery and then press and hold the SET button.
- While still holding the SET button, put the battery back.
Who makes gatehouse door locks?
“Who makes Gatehouse locks?” is a question we often get asked. And, the answer is simple—Lowes.
How do you reset a Kwikset deadbolt lock?
1 Factory Reset
- Open your door.
- Extend the latch bolt.
- Slide up the cover to open the back of your lock, exposing the buttons beneath.
- Push and hold the reset button for 10 seconds, until the lock beeps.
- The light ring will flash red, then spin amber.
- The lock has now been restored and is ready to be set up again.
Does Gatehouse make good locks?
As you can see Gatehouse offers a lot more products than just locks. However, their deadbolts are a great alternative to more expensive brands offered by the big names in the market. If you want a quality product at a more affordable price, this is a brand that you want to look at.
What is the programming code for the gatehouse deadbolt?
Gatehouse Electronic Keypad Deadbolt comes with a preset programming code—123456. This code gives you access to all other settings. That is, you need to enter your programming code to add or delete user codes, reset the lock, etc. Note: Your programming code is also your master code, which is 123456 (preset).
How do you reset the battery on a deadbolt?
1. Remove the inside escutcheon to gain access to the deadbolt battery. 2. Disconnect the battery from the deadbolt. 3. Momentarily press the “Schlage” button on the face of the deadbolt a few times, with the battery removed. 4. While holding the “Schlage” button depressed, reconnect the deadbolt battery.
How do you change the code on a gatehouse lock?
This is how you change the code on your Gatehouse door lock. Enter your 6-digit programming code and hit the lock button. Enter “30” and hit the lock button. Enter 1-2-3-4-5-6 and then the lock button to delete this default user code.
How do you reset a be367 deadbolt to factory settings?
Continue to hold the “Schlage” button until the long green pulse is completed. NOTE: The complete “Schlage” button red and green flashing sequence should take no more than 10 seconds to complete. Repeat steps 2 through 5 if the red and green flashing sequence is not provided as indicated.