Contents
How do you fasten cove molding?
Install the corner pieces with a nail gun and 2 1/2 inch nails at an angle. Once your corner pieces are up, nail up the cove moulding placing a nail on the top and bottom where you marked your studs. Sink them into the groove of the cove moulding so they are easily hidden.
How do you measure cove molding?
Take a measurement of the length of crown molding you need. Run a tape measure from one corner to the next and read the measurement. On inside corners, the end of the tape represents the long point of the miter cut, but on outside corners, the end of the tape is the shortest point of the cut.
What does cove molding look like?
Cove. Also known as coving, cove molding is plain, concave-shaped trim employed where walls and ceilings meet. It can also be used on stairs, at the meeting of risers and treads. In essence, cove may be considered a less ornate version of crown.
How do you cut the corners of a cove molding?
For most standard corners, this will be 45 degrees. Lift the blade and then slide the cove molding through until the cut line matches the line on the miter box. Select the type of angle and then cut. Repeat for each piece of cove molding. When the angles are done being cut, test fit them to the wall.
Can you use a coping saw on cove molding?
But many inexperienced do-it-yourself enthusiasts have difficulty making concave cove molding fit neatly with adjoining miter cuts. The solution is using a coping saw to fit one end of a piece against the face of the adjoining piece. This saves time and improves the uniformity of inside corners.
How to install cove molding on the ceiling?
How to Install Cove Molding on Ceiling Measure each wall and purchase cove molding from your local hardware store. If you plan on having the store cut the pieces to size make sure to subtract the width of two corner pieces from the wall size. Prepare your molding by sanding any rough spots and painting it to match existing trim in your house.
How did the cove molding get its name?
Cove molding is aptly named for its concave profile that softens the look of the intersection where a ceiling meets a wall. Typically, ceiling moldings are joined at inside corners with miter cuts at the ends of each piece.