Contents
How do you remove the brush bar on a Dyson?
Press the brush control button next to the On/Off switch to stop the brushes for use on delicate rugs, loop pile carpets and hard floors. Press the button again to restart the Brush bar for vacuuming carpets.
Where is the brush bar on off Dyson?
Press the brush control button located next to the ON/OFF switch to turn the brushbar off for vacuuming delicate rugs and floors.
How do you remove the brush from a Dyson animal?
Rotate the end cap to unlock and remove. Gently slide the large Brush bar away from the Cleaner head and remove the end cap from the Brush bar. Lift the smaller Brush bar up to remove. Wash both the large and small Brush bar until the water runs clear.
How do you replace brush bar on Dyson DC14?
Turn down the squared tabs on the brushbar so that they face outward. Use a screwdriver to pry the belt up from the brushbar. Be careful not to cut the belt with the screwdriver. While holding the belt, pull the brushbar to the left and remove it from the vacuum.
How do you remove a roller brush from a Dyson vacuum?
Remove the screws from the base plate with the flat-head screwdriver. Turn the screws counterclockwise, or to the left, to remove them. Take the base plate off of the bottom of the vacuum and set it aside. Locate the rubber belt that is attached to the roller brush. Remove the rubber belt by pulling it off of the roller brush.
How do you put an attachment on a Dyson vacuum?
Dyson attachments refer to the interchangeable brushes and tools that lock into the end of your vacuum hose to clean unique surfaces. To put an attachment on your vacuum, press the red button near the base of the handle to release it and turn it into a handheld wand.
Where is the level switch on a Dyson vacuum?
Place one foot on either side of the front corner of the vacuum while pulling the handle towards you. Now the vacuum is ready to clean. Look down towards the right side of the vacuum base to locate the level adjustment switch on the vacuum. This switch will be labeled with two different settings: “bare floors” and “carpets.”