Contents
How does a push down tub stopper work?
A push-and-pull stopper is very similar to a lift-and-turn stopper in design and look, but it is pushed down to close and pulled up to open rather than twisting to open and close. Installation is also similar, with the stopper body attached to the drain with a setscrew found under the cap of the stopper.
How do you remove a push type tub drain?
Remove the knob on the top of the stopper. Hold the body of the stopper in place with one hand and with the other hand unscrew the knob by turning it counter-clockwise. If the knob will not unscrew, then wrap the rag around the knob and use the pliers to help remove the knob.
How do you remove a push and pull drain stopper?
How to Remove a Push-Pull Drain Stopper:
- Set the drain to its open position.
- Lift up on the drain stopper’s knob and turn it counterclockwise.
- After enough turns, the drain stopper should be unscrewed and come free from the drain opening.
How do you remove a push pull drain stopper?
To remove a push-pull stopper, set it in the open position and turn the knob counterclockwise with one hand while holding the body of the stopper in the other. For increased leverage, hold onto the body with a towel and use a pair of pliers to turn the knob. For the lift-and-turn, set the drain to open.
Why does my pop up drain leak?
Pop-up drains sometimes spring a leak at the point where the pivot rod enters the drain pipe. Leaking can start if there is loosening or cracking of the compression nut that holds the pivot rod in the drain pipe. If a leak is traced to this nut, it can usually be stopped by tightening the nut.
Why won’t my pop up plug stay down?
If the stopper moves as it should but doesn’t stay put, all you need to do is tighten the nut (turn it clockwise). If the action is too stiff, loosen the nut a little. Check the action and adjust until it feels about right. Make sure the two rods are connected.
How do you remove a drain stopper from a tub?
The toggle lever expands the shaft of the stopper to seal a pair of O-rings and block the drain. With the stopper in the open position, simply grasp the plug by hand and pull upwards with a wiggling motion to remove it from the drain opening.
How do you fix a lift and turn bathtub drain?
To fix a lift-and-turn bathtub drain that won’t stay open to drain, you’ll need to completely remove the stopper from the drain. Start by lifting the drain in the open position. Hold it in place by gripping the larger part of the drain with one pair of pliers, and grab the metal handle on top with the other pair of pliers.
Push-pull drain stoppers are quite similar to toe-touch styles, but rather than being spring-loaded, they are simply raised and lowered by hand by means of a small knob on the top. Lift the stopper to the open position. Hold the stopper body firmly by hand, and twist the knob counterclockwise to remove it.
What to do if your bathtub drain won’t stay open?
Hold it in place by gripping the larger part of the drain with one pair of pliers, and grab the metal handle on top with the other pair of pliers. Turn the smaller handle counter-clockwise while holding the larger part of the drain steady with your other hand.