Menu Close

How many quarts of tranny fluid does a 400 Turbo take?

Jim Brown

How many quarts of tranny fluid does a 400 Turbo take?

You can expect to use between 11 and 12 quarts of fluid in the stock version.

What happens if you overfill a TH400 transmission?

If you’re no more than a quart over full, it should be fine for a Th400. If it were a problem, it would be foaming and spitting out the vent tube.

Does a TH400 have overdrive?

Some refer to the 4L80E as the TH400 with an overdrive ratio, as much of the internals are interchangeable. TCI has a complete line of 4L80E transmissions in the Street Fighter and Super Street Fighter trim levels.

How do you check transmission fluid on a TH400?

Do I check the transmission fluid in my Turbo 400 when it’s idleing??? Make sure to warm up the motor and transmission fluid first. Start the car, let it come off of high idle, pull the dipstick out and wipe it off then reinsert it and pull it out again to check the actual working level of the fluid.

Can you flush transmission at home?

ยป A transmission flush can be performed (DIY) using the transmission’s pump without a flush machine. A transmission flush is a process in which the fluid in an automatic transmission is flushed out of the transmission and replaced with new ATF.

What kind of transmission fluid goes in a TH400?

I’d recommend Dexron III too, but Dex 3 is more of a friendly companion to TH350. For TH400, you have more torque pushing through a high profile engine. Similarly, what is the fluid capacity of a th400 transmission? You can expect to use between 11 and 12 quarts of fluid in the stock version.

When did GM start using 400s on TH400 trucks?

GM put them on the HD th400s in the 1 ton trucks , late 70s e, early 80s. The 400s in the 1/2 tons were the short pan and not heavy duty. Either way, 2 extra qts is still better, just not on the pocket book, especially since this will be the 2nd time to buy 13 qts of fluid!

Is the deep pan on a GM TH400?

The deep pan is a factory GM pan , not an aftermarket. GM put them on the HD th400s in the 1 ton trucks , late 70s e, early 80s. The 400s in the 1/2 tons were the short pan and not heavy duty. Either way, 2 extra qts is still better, just not on the pocket book, especially since this will be the 2nd time to buy 13 qts of fluid!

Where is the drain fluid on a GM TH400?

I’ll update when I get the trany back and in, hopefully by wednesday. on a turbo 400 tranny the exact full level is even with the modulator, located on passenger side of transmission, remove the modulator and drain fluid, if overfilled.

How many quarts of tranny fluid does a 400 Turbo take?

Jim Brown

How many quarts of tranny fluid does a 400 Turbo take?

You can expect to use between 11 and 12 quarts of fluid in the stock version.

What fluid does a Turbo 400 take?

The Turbo 400 transmission can use any high-quality automatic transmission fluid. The transmission fluid should not break down under high pressure or temperatures.

What happens if you overfill a TH400 transmission?

If you’re no more than a quart over full, it should be fine for a Th400. If it were a problem, it would be foaming and spitting out the vent tube.

Is a TH400 better than a TH350?

The TH350 uses a mechanical kick down switch, whereas the TH400 uses an electric one. A lot of people claim that he TH350 has less drivetrain loss than the TH400, which means that all things being equal, the TH350 is going to get more power to the rear wheels from an engine with equal power.

Does a TH400 have overdrive?

Some refer to the 4L80E as the TH400 with an overdrive ratio, as much of the internals are interchangeable. TCI has a complete line of 4L80E transmissions in the Street Fighter and Super Street Fighter trim levels.

What type of ATF fluid do I need?

Dexron III/Mercon – This is one of the most common fluids on the market. Most GM and Ford units call for this type of ATF, as well as many imports. If your owners manual recommends any form of Dexron, or any Mercon – other than Mercon V – this is the fluid you want.

What is the best type F transmission fluid?

Valvoline Type F Automatic Transmission Fluid (ATF) is a high quality non-friction modified fluid. It is designed to meet the Ford specification M2C33-F and M2C3-G. It is recommended for use in all Ford passenger car automatic transmissions prior to the 1977 models as well as many 1977 through 1980 models.

How do I check my th400 fluid level?

Start the car, let it come off of high idle, pull the dipstick out and wipe it off then reinsert it and pull it out again to check the actual working level of the fluid. Park vehicle on level surface, engage parking brake and start engine. Leave car in neutral or park.

What happens if you overfill a Turbo 350 transmission?

The main concern is the transmission will get hot and spit the fluid out if it is overfilled too much. Possibly on the engine or headers where it will catch fire. The other thing that will happen is it will cause the transmission to slip and eventualy fail.