Menu Close

How much crushed concrete do I need calculator?

How much crushed concrete do I need calculator?

Multiply the length (L), in feet, by the width (W), in feet, by the height (H), in feet, and divide by 27. This will tell you how many cubic yards of crushed stone you need.

How thick should a crushed concrete driveway be?

Generally, digging to a depth of nine to twelve inches is sufficient. Make sure to dig to an even depth over the entire area.

How much crush and run do I need for driveway?

According to the Home Depot, 4 to 6 inches of rock or gravel is needed for a driveway. Convert your estimated rock depth in inches to feet by dividing the number of inches by 12. For example, if you decide on a depth of 4 inches of rock, the conversion is 0.33 feet.

How deep should a crushed stone driveway be?

Keep in mind that you’ll need to install 3 different layers of crushed stone in order to complete the project, and that each layer should be 4-6″ in depth. This means that your driveway should be between 12-18″ deep.

How many yards are in a ton of crushed concrete?

Since there are 2000 pounds in a ton this is 2700

Which is better crushed concrete or crushed asphalt?

crushed concrete affordable: crushed concrete both are the better and low cost for construction. Crushed Asphalt required far-fewer of raw resources for the virgin Asphalt. Considering facts about that Asphalt containing a high volume of the oil and volatile, this is making a huge difference.

How much area does a ton of crush and run cover?

approximately 135-123 square feet
COVERAGE GUIDELINES:1 ton covers an area approximately 135-123 square feet to an average depth of 2 inches.

How to figure out how much crushed stone you need for a driveway?

There are several formulas you should be familiar with to figure out how much stone you will need. A cubic yard is any volume of material that is 3 feet long by 3 feet wide by three feet deep, or 3′ X 3′ X 3′. To find how many cubic yards you will need multiply the length times the width times the depth and divide by 27.

How big of an area do you need for crushed concrete?

For example, an 18’ by 10’ area is 360 square feet. Second, determine how many layers or how deep you will need to cover the area depending on the type of project. Usually you will need at least two inches of material. Next you will need to determine the size of the material you’re using.

How much gravel do you need for a driveway?

Most driveways should have a depth of 6-8″ of gravel. The formula to find volume is length × width × depth. Multiply the width in yards by the length in yards by the depth in yards to find the cubic yards of gravel needed.

How long does it take to install crushed concrete driveway?

Crushed concrete driveways can take a full day or more to complete. Make sure you’re ready and able to operate equipment, lift heavy stone, and spend time spreading materials. Before excavation can occur, you’ll have to mark off the area where you’ll be placing the materials.