Contents
How much does it cost to install a grease trap?
Q: What will a grease trap cost my business? A: The average install for a small grease trap (0-100 gallons) is between $250 and $1500. The average cost for the installation of a new grease trap (750-1500) is between $4,000 and $8,500. Grease recovery devices cost between $3,500 and $6,000.
Where is a grease trap usually installed?
Hydromechanical grease interceptors (commonly called grease traps) are usually installed underneath the 3 compartment sink or in the floor of the kitchen. They trap grease over time and need to be pumped frequently, sometimes even weekly.
Can I install my own grease trap?
Determine where to install the grease trap The most convenient place to install a grease trap is beneath your sink but it can also be installed outside your home. Unless your home has several sinks that are regularly used for cooking, setting it up beneath your sink is recommended.
What should be connected to a grease trap?
The short answer is all of them. Grease traps and grease interceptors should be used to collect all the FOG (Fats, oils, and grease) coming out of your kitchen, so you can stay up to code on your local ordinances. …
How long does it take to install a grease trap?
How long does it take to install a grease trap? The price and installation cost of the grease trap are significantly lower to the fact that less labor is required and can be done in less than one day. Although, small grease traps will require more service, which can be more costly in the long run.
How do you size a grease trap?
Using the calculator below will give you the approximate grease trap size for your application:
- Calculate the capacity of the sink in cubic inches (measurements of one bowl):
- Length (Inches)*
- Width (Inches)*
- Depth (Inches)*
- Capacity of sink in cubic inches*
- Multiply total by the number of bowls:
- Number of Bowls*
What is the difference between a grease trap and a grease interceptor?
Grease traps were invented in the 1880’s, and the technology has reminded nearly unchanged ever since. The difference between a grease trap and a grease interceptor is the flow rate of wastewater that the device can handle. A grease trap works well with a lower volume of flow; less than 50 gallons per minute.
How often should grease trap be cleaned?
every one to three months
The frequency of restaurant grease trap cleanings vary with how often the kitchen produces FOGS. On average, cleanings should be performed every one to three months. Restaurants, cafeterias and other commercial kitchens are advised to set up a regular service schedule to avoid missing critical cleanings.
Where are grease traps installed?
The best location for grease trap installation is under the sink, but it can also be installed outside of the house. External grease trap installation is best for homes with several sinks because the drainage pipes can all be connected to the one common pipe and fitted to the grease trap.
How big of a vent do you need for a grease trap?
Venting the grease trap is an important requirement of the pre-treatment installation. The venting pipework must be 100mm diameter minimum. All grease trap installations must have:
Do you need a grease trap in your restaurant?
Laws in most states, especially in restaurants and food preparation businesses, mandate the installation of a grease trap. It should be installed in an accessible location, to allow the owner to clean it occasionally. Here are three steps to follow in grease trap installation. Grease trap size will vary from one model to another.
Why are grease traps so expensive to install?
In order for grease traps to be effective, they must be properly sized, constructed and installed into your plumbing system. Because of these specific requirements, grease traps are traditionally more expensive than other plumbing operations.