Contents
Should drip edge be tight to fascia?
A metal drip edge will help protect the sheathing under the roof, but if it’s installed too closely to the fascia board, it can still cause water to be drawn into the fascia. The best installation method is to leave a gap between the drip edge and the fascia board, about the width of a finger.
What color should flashing be?
The flashing will come in either white or brown. If your trim is either of these colors that is fine. If your trim is white and the flashing is brown you MUST paint the flashing white otherwise the fascia will look too narrow to support the roof.
Do you paint the drip edge?
Yes you can paint the aluminum drip edge and it hold up very well. Just be sure it is clean and paint it with a good exterior acrylic primer and finish with a exterior acrylic semi-gloss house paint. The most common colors for drip edge are white and brown.
What does drip edge flashing do?
Drip edge is a metal flashing that is installed at the edges of the roof to help control the flow of water away from the fascia and to protect the underlying roofing components.
How far should shingles overhang drip edge?
¼ to ¾-inch
Asphalt shingles should overhang the exterior edge of the drip edge by ¼ to ¾-inch. Check local building code for drip edge requirements prior to the start of your roofing project.
Is metal drip edge required by code?
Drip edges have been required by the International Residential Code since the 2012 revision. Most states in the U.S. have adopted the IRC, which means that drip edges are required for most buildings in those states. Because of how important it is, a drip edge is something that any building owner should consider.
Does flashing go over or under shingles?
Instead of installing the step flashing between shingles, the flashing rests on top of the shingles. It’s not unusual to see sealant installed when sidewall flashing is missing. Sealant will eventually dry, shrink and crack. You’ll see sealant substituted for flashing in a lot of different areas on roofs.
Should drip edge match trim or shingles?
The most common colors for drip edge are white and brown. However, some roofing companies can provide color match drip edge. The color is often chosen to match the shingles or the gutters to create a seamless look. The color can also be chosen to match the shutters or trim of the house and act as an accent color.
Which is the best color for drip edge roofing?
The most common colors for drip edge are white and brown. However, some roofing companies can provide color match drip edge. The color is often chosen to match the shingles or the gutters to create a seamless look.
How big does drip edge need to be?
Metal Edge Drip: A drip edge has to be resistant to possible corrosion and should be 36 gauge or larger. Additional materials: tape measure, hammer, pencil, ladder, small roofing nails, tin snips
Which is the best material for drip edges?
Aluminum: A common material for drip edges, aluminum isn’t as strong as steel. It doesn’t corrode and is often sold in colors that match the rest of the home exactly.
Where do you place a drip edge on a roof?
A drip edge should be placed on the whole perimeter of the roof, especially the corners, as much as possible. They have a small metal flange that is bent away from the fascia board. Drip edging directs water away from the fascia and into the gutter to prevent damage to the roofing underlayments of your house.