Contents
What are the parts of a door handle?
The parts of a door handle include knobs/levers, latch mechanisms, strike plates, boxes and cylinder locks.
- Knobs and Levers. The most obviously noticeable part of the door handle is the knob or lever that actually allows the door to open.
- The Latch Mechanism.
- Strike Plates and Boxes.
- Door Knob Locks.
How do you fix a spindle on a door knob?
Use a simple procedure to replace a broken spindle.
- Open the door part way.
- Locate the small setscrews or hex bolts at the inner portion of each door knob.
- Pull out both sections of the broken spindle from the door lock.
- Fit one end of the new spindle fully into the square port at the inner end of a door knob.
How do you measure a door handle for a spindle?
To find the spindle length of your handles measure the bit that sticks out from the back of your handle as shown on the photo to the left.
How do you describe a door handle?
A door handle is a small round object or a lever that is attached to a door and is used for opening and closing it. I turned the door handle and found the door was open.
What is a door handle backplate?
Lever on backplate handles come in a range of designs to suit all styles of interior. Available with or without keyholes, the contemporary backplate discreetly conceals screws and turn and release mechanisms for a neat and stylish finish.
What do you mean by spindle?
1 : a slender round rod or stick with narrowed ends by which thread is twisted in spinning and on which it is wound. 2 : something (as an axle or shaft) which has a slender round shape and on which something turns. spindle. noun.
Are all door handle spindles the same size?
Q. Are all spindles the same size? A. They can vary but 8mm (5/16″) square has become a general “standard” for spindles which are European manufactured although 7mm square can also be seen particularly those imported from Australia or New Zealand.
What kind of spindle do you use for a door handle?
The drilled spindle is meant for use with a long grub screw, which locates into the threaded holes. Whilst providing a very secure fixing right through the spindle, the spindles’ pre-set drilled intervals makes for pre-set junctures at which the door handle or knob can be secured, so can make for a slightly less precise fitting against the door.
Where does the spindle go in a lock?
It passes through the mortice latch or tubular lock (located within the door) and the two handles slot on either side of the door. Turning the knob (or pushing down on a lever handle) will rotate the spindle which in turn makes the latch move back and forth allowing the door to open.
Where is the spindle on a mortice door?
It passes through the mortice latch or tubular lock (located within the door) and the two handles slot on either side of the door. Turning the knob (or pushing down on a lever handle) will rotate the spindle which in turn makes the latch move back and forth allowing the door to open. Is there a standard spindle size? Yes.
What to do if your door spindle is too long?
On occasion, new spindles supplied with door furniture may be initially too long, such as when used on very thin interior doors. In this instance, it is simply necessary to place the spindle in a vice, and cut it down with a hacksaw.