Contents
What causes corrosion in distributor cap?
One of the most common reasons, is that your distributor cap has a hairline crack that is admitting water and condensation. Another reason could be that your alternator is overcharging your battery system, and generating a buildup of corrosion producing battery acid.
How do you clean a corroded distributor?
Clean the inside with a compressed air, spray WD 40, let sit for an hour or so, use a soft brissel brush to clean and give it another blast of air and another coat of WD 40. Replace the cap, rotor and wires. Give her a drive. You could replace the whole distributor, but it doesn’t sound like its necessary.
How do you test an MSD distributor?
Magnetic Pickup in the Distributor The magnetic pickup in MSD Distributors can also be checked with an Ohm meter to make sure it is within operating specifications. Once again, connect the Ohm meter’s leads to the two terminals of the pickup. The resistance should be within 400 – 1,300 ohms.
How do I keep moisture out of my distributor cap?
Turn off the vehicle and spray the spark plug wires and the inside and outside of your distributor cap with WD-40. Using WD-40 to repel water from spark plugs, distributors, alternators, and batteries is a good way to prevent corrosion and keep moisture away.
How do you remove moisture from a distributor cap?
Step 1 – Access. Remove the coil wire from the distributor cap and follow this with the spark plug wires, marking which wire goes where on the cap. Step 2 – Cleaning and Seal. Using a clean, dry rag, wipe out the inside of the distributor cap and leave it in a warm area to dry out.
What’s the best way to clean a distributor cap?
You can then pull the cables gently out from the distributor cap. Step 2: Get the Cap Out- Unscrew two screws on the side of the cap and try to release it by pulling it up gently. Step 3: Clean the Terminals- Using a soft piece of abrasive rub the contact terminals to remove any carbon build-ups and any oxidation on the metal terminals.
What does a bad distributor cap do to a car?
The distributor cap and rotor are responsible for keeping the distributor away from the engine. Furthermore, they keep the distributor’s engine parts neat and clean. The rotor and cap also support the high volts of energy and delivers it to the spark plugs. Here are some of the bad distributor cap symptoms you must know.
What is the function of the distributor cap?
The distributor cap and rotor are responsible for keeping the distributor away from the engine. Furthermore, they keep the distributor’s engine parts neat and clean.
Why do I have Crud on my distributor cap?
Many people report that when they perform some maintenance in their vehicle and when they pulled up the distributor cap, they find a strange build-up. It could be crud at the end of each spark plug wire terminal or corrosion on distributor cap terminals.