Contents
What causes snow blower to sputter?
Gas Snowblower: Engine runs rough. A clogged fuel filter will also prevent the engine from getting fuel, causing the engine to sputter or run rough. Check the fuel filter and replace it if clogged. A dirty spark plug won’t ignite the fuel consistently, causing the engine to miss and sputter.
Why does my snow blower only runs on full choke?
Snow Blower will only run when on full choke. When the choke is on it provides the engine with more fuel than it needs. When the spark plug gets soaked it will not spark correctly and ignite the fuel. If this is the case, the spark plug will have to be replaced.
Why does my snowblower dies when Auger engaged?
It sounds as if the auger pulley is stuck. If all of the pulleys are fine and the engine still stalls, it is most likely a fuel issue. Use only fresh fuel less than thirty days old. If the fuel was left in the tank over the summer, it could have gummed up the carburetor.
Why does my snowblower idle up and down?
If the snowblower engine RPMs are surging up and down, check the following parts for damage: springs, gasket, carburetor, and spark plug. There are springs on the carburetor that allow the butterfly valves to open and close properly. The springs also ensure the governor is operating properly.
Why does my snowblower run better on half choke?
If you have a choke lever separate from the throttle and the engine only stays running when choked, then your carburetor has a fuel blockage causing it to be too lean(not enough fuel). The only way to balance the fuel air mixture is to restrict the air by choking it. That’s why it runs better on choke.
Why does my snowblower die when I turn off the choke?
Running with the choke on pulls more fuel than air. Running for that much time with the choke on, may have pulled some specks of debris into the main jet, restricting the fuel flow. Engine will run on choke as it is pulling more fuel, but die as choke is turned off.
Why does my snowblower keep stalling and stalling?
Snowblower Troubleshooting The carburetor might be clogged. A clogged carburetor is most commonly caused by leaving fuel in the snowblower for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the engine to stall.
Why is my snow blower not working properly?
CR’s snow-blower experts put together a list of problems that can, when neglected, lead to poor performance or worse—a trip to the repair shop when it’s at its busiest. Problem: The engine stalls or won’t start. Solution: Stabilize your fuel while at the gas pump.
Why does my snow thrower stop after it starts?
I assume you are having a problem with the engine stalling after it starts. Usually when this happens, it is because the choke is turned off to early. Once the engine starts turn the choke to half until the engine runs rough then turn the choke off. Old fuel will also cause this problem.
What to do if your lawn mower stalls?
This sticky fuel can clog up the carburetor and cause the engine to stall. If the carburetor is clogged, try cleaning it with carburetor cleaner. If cleaning the carburetor isn’t effective, rebuild or replace the entire carburetor.