What command is used to configure IPv6 static routes?

In Cisco Routers, IPv6 static routes can be configured using the following Cisco IOS command ipv6 route from Cisco IOS global configuration mode.

What is the correct way to configure an IPv6 default route?

Default IPv6 Static Route – A default IPv6 static route is created by specifying the destination IPv6 prefix and prefix length all zeros, ::/0.

What is the correct command to configure a default static route?

Use the ip route next-hop command to allow protocol resolution through the default route. If the default route itself is a static route, you must configure the ip route next-hop-enable-default command to resolve other static routes through the default route.

Which command would create a valid IPv6 default route?

Which command would create a valid IPv6 default route? Explanation: The correct prefix and prefix length for a default route is ::/0, which matches any address. ::/128 matches only the specific address of all zeros.

Are IPv6 addresses static?

IPv6 address is not assigned, so the IPv6 address from the Ethernet configuration is set for a Static address of Ethernet interface. DHCPv6 server maintains a database of leased IPv6 addresses, and assigns to the client an unused IPv6 address.

How do I configure a static route?

Configuring Static Routes

Navigate to the Configuration > Network > IP > IP Routes page.
Click Add to add a static route to a destination network or host. Enter the destination IP address and network mask (255.255.
Click Done to add the entry. Note that the route has not yet been added to the routing table.

What is the command for default route?

Use the ip default-gateway command when ip routing is disabled on a Cisco router. Use the ip default-network and ip route 0.0. 0.0 0.0. 0.0 commands to set the gateway of last resort on Cisco routers that have ip routing enabled.

What does the 5 at the end of the command signify?

The 5 at the end of the command signifies administrative distance. This value is added to floating static routes or routes that only appear in the routing table when the preferred route has gone down. The 5 at the end of the command signifies administrative distance configured for the static route.

https://www.youtube.com/watch?v=hDCSdUcurPY

How to configure a recursive IPv6 static route?

To configure a recursive IPv6 static route, use the following command format: e.g. Router(config)# ipv6 route <ipv6-prefix/prefix-length> <next-hop-ipv6-address>. Default IPv6 Static Route – A default IPv6 static route is created by specifying the destination IPv6 prefix and prefix length all zeros, ::/0.

How does an IPv6 static router work?

Router (config)# ipv6 route <ipv6-prefix/prefix-length> <outgoing-interface-type> <outgoing-interface-number> Recursive IPv6 Static Route – A recursive static route is created when specifying the next-hop IP address. This method enable the router to perform a recursive lookup in the routing table in order to identify the outgoing interface.

When to use the default route in IPv6?

The Default Route is a type of static routing. They are used whenever the destination of the packet is not reside in the routing table of the router. So, the traffic is sent to the destination mentined in default route if there is no route information in the router about this destination.

When to use static route in Cisco IOS?

IPv6 Static Route Configuration on Cisco IOS As you know, Static Route is the route that you manually define on a router.This is done when we do not want to use Routing Protocols for small part of a network. Or, in large networks some small amout of routing is done via static routing. For IPv6, we use IPv6 Static Routes.