Contents
What does ANL mean in fuses?
ANL type fuses are the most common types of fuses used to protect the main power wire in car audio systems. ANL fuses are available from Bussmann in sizes from 35 amps to 750 amps. The following photo shows a 200 amp ANL type fuse. In this fuse holder, there is no wire-terminal block.
How do I run an accessory wire to a fuse box?
If you are connecting a true automotive accessory, wiring the device is relatively straightforward. Just connect and crimp the power wire from the accessory to the fuse tap, plug the fuse tap into an open slot on the fuse panel, and then secure the ground wire from the accessory to a grounding screw.
What is an inline fuse holder?
In-line fuse holders are wire-mounted holders that connect anywhere along a circuit to protect specific lines. They allow these lines to be isolated in the event of a fault so that the rest of the wiring system won’t be affected.
Can I use a 10 amp fuse instead of a 5 amp?
Possibly yes. It is possible to short out a circuit by overdrawing more than 5 Amp by removing the 5 Amp fuse and putting in a 10 Amp fuse.
Where do I connect the remote wire for my amp?
The turn-on wire (also called the remote wire) is located behind the stereo. On aftermarket stereos, it’s usually a blue and white wire. The remote wire will “tell” your amplifier to turn on whenever the stereo is powered up (usually, whenever the vehicle is turned on).
What’s the best way to wire a fuse holder?
Crimp down tightly on the connector with the crimping pliers. Insert the properly rated amperage fuse into the fuse holder. Connect the two halves by compressing them together and then twisting to lock into place. Restore the electrical power to the device.
Where are the fuses on a camper van?
Slide the wire lug over the ANL Fuse holder stud; replace the washer and lock washer. Next I’m going to Install the ANL Fuses . The fuses simply slide in place between the washers like this:
How to find the maximum fuse amperage for AWG?
A Find the MAXIMUM FUSE AMPERAGE by following your AWG wire size (from Part 1 of this series) across the chart. Maximum fuse amperage reduces nuisance blows but offers less protection for the wire. Select: Outside Engine Room or Inside Engine Room grey bar
Where does the wire go on a camper van?
All of the positive wires will fit on the ANL Fuse holder studs with a 5/16” lug. Slide the wire lug over the ANL Fuse holder stud; replace the washer and lock washer.