Menu Close

What is the best tool to cut shingles?

What is the best tool to cut shingles?

Tin snips are very sharp, powerful scissors designed to cut through metal, but they can be equally effective for small, complex cuts in shingles. If you need to trim the shingle to fit around pipes or small vents, then tin snips are your best choice.

Can you cut shingles with an angle grinder?

These blades attach to several types of saws including grinders, portable circular saws and chop saws. Masonry cut-off blades effectively cut through asphalt shingles, but they quickly wear and become blunt.

How do you cut shingles off the edge of a roof in a straight line?

Hook Knife Method Position the side of hook knife against the drip edge beneath the shingle, with the blade facing upward against the shingle medium. Using upward pressure, slide the knife toward you; this scores the shingle underside. Bend the shingle from the top and neatly break it off.

Should shingles overhang drip edge?

Asphalt shingles should overhang the exterior edge of the drip edge by ¼ to ¾-inch. Check local building code for drip edge requirements prior to the start of your roofing project.

How do you start cutting shingles?

To begin installing the first shingles on your roof, cut off the three tabs on the shingle. Using a utility knife, cut them off at the bottom of the adhesive strip. This should leave you with about 1/2 of the shingle left.

Can you cut through shingles with a circular saw?

Although roofers commonly cut asphalt shingles on site by scoring them with utility knives, some projects call for more speed or volume, making power saws, such as circular saws or reciprocating saws, handy for cutting asphalt shingles. This should leave you with about 1/2 of the shingle left.

How much should a shingle overhang drip edge?

Yes. Shingles should not extend more than 3/4” (19 mm) past the drip edge. If shingles overhang the edge of the roof by more than 3/4” (19 mm), then they are not supported and may crack and break off. In addition, the wind resistance at the roof edge may be compromised.

What’s the best way to cut a Shingle off a roof?

Position the side of hook knife against the drip edge beneath the shingle, with the blade facing upward against the shingle medium. Using upward pressure, slide the knife toward you; this scores the shingle underside. Bend the shingle from the top and neatly break it off.

How do you finish shingles on gable end?

Excellence is its own reward! so, you run a scab of 3/4″ x 3-1/2″ furring along top of the wall to the soffit. Then cut the cedars to the bottom of it. Then it becomes a shim and nailer for you to apply your good frieze board. The frieze can also have a scotia or other molding to dress it up.

What’s the best way to cut a gable end?

With a long level—sometimes an 8 ft.’er—I mark a horizontal line on the wall, butting one end against the rake. Then I draw a plumb line up to the rake on the high side. I strike that plumb line at an even foot increment—like 5 ft., 6 ft., 7 ft., or even 8 ft., if I can reach out that far and the gable is wide enough.

Where do you cut shingles for ridge cap?

Cut the shingles lengthways between the middle adhesive strip and where the dimensional portion of the shingles attach. Many installers use the cut off tab strip to narrow the gap between the last course or row and the ridge, fastening it with capped roofing nails in the prescribed pattern.