Contents
What is the best tool to use to cut drywall?
There are three main types of drywall cutting tools: a utility knife, jab saw and drywall circle cutter. The simplest and most common way to cut drywall is by using a utility knife. These tools are durable, lightweight, easy to use and ergonomically designed. They’re also affordable and create little to no dust.
How do you cut in place on drywall?
Plunge the tip of a jab saw into the drywall where you want to start cutting. Place the sharp tip of the jab saw against the drywall, then wiggle it back and forth while applying strong pressure to push it straight through using your dominant hand.
What side of the drywall do you cut?
How to Make Simple Knife Cuts to Drywall. In most cases, drywall is cut by scoring through the paper on the finish side (the one with white paper) using a sharp drywall knife. As soon as you notice the blade dulling, turn it around or replace it.
Can you use an angle grinder to cut drywall?
An angle grinder will allow you to cut plaster with ease. However, you should be cautious to avoid damaging the wall. Remember a small mistake while cutting the wall might cause the whole wall to crash down.
Can an oscillating tool cut drywall?
For getting precise cuts in less time, an oscillating multi-tool is the best tool to cut drywall with. Your other drywall cutting tools might still come in handy for some of your cuts, but an oscillating multi-tool can be great for long, straight cuts as well as smaller precision cuts.
How do you cut drywall cleanly?
Use a pencil to draw a scoring line. With a sharp utility knife or other cutting tool, follow the pencil line and lightly cut through the paper layer of drywall. Tip: The best tools for cutting drywall are utility knives, putty knives, reciprocating saws, oscillating multi-tools and track saws with dust collectors.
https://www.youtube.com/watch?v=jIhSkCtLEN0
What’s the best way to cut a piece of drywall?
Cutting a Large Sheet of Drywall Measure where you need to cut your drywall with a tape measure. Hold a drywall square or T-square against the drywall where you need to cut it. Run a utility knife along your square to cut the paper and some of the drywall core. Score both the front and back to cut a thin strip.
How do you cut a pilot hole in drywall?
Measure the light from two established edges. Read the distances at the near and far sides of the box. Write them on the framing if you have a short memory! Transfer the measurements to the drywall and draw a box. Drive a nail through the center point for a pilot hole.
Can a utility knife be used to cut drywall?
When you score the paper with a utility knife, the crumbly gypsum breaks cleanly, directly in line with the score. When you’re scoring with a utility knife, use only enough pressure to barely cut the paper. Cutting deeply into the gypsum core will only result in dull knives and a strained wrist.
How to make a small hole in drywall?
1 Measure the location of the fixture and trace its contour on the drywall sheet. 2 Use a drill machinery and a large drill bit to make 4 holes around the rectangle. 3 Use a jigsaw or a drywall saw to cut the patch in drywall, positioning the blade in the starting holes.