Contents
Where is the drain hose on Whirlpool dishwasher?
With the panel removed, locate the drain hose. It is connected to the pump located below the lower spray arm. The drain hose runs from the pump to the sink drain, or to the air gap on top of the sink.
What are the two hoses on a dishwasher?
The incoming dishwasher drain hose connects to one fitting, while a secondary hose runs from the other fitting to the kitchen sink’s drain pipe or garbage disposer. The air gap works by allowing fresh air into the drain hose if there is a backup causing negative pressure.
Is water supposed to stay in dishwasher hose?
Water in this area is actually perfectly normal, useful even. It’s there to keep the seals from drying up. It drains when a cycle starts and is replaced with fresh water at the end of the cycle.
How to install a drain line on a dishwasher?
Loosen the screw on the hose clamp that holds the drain line to one of these locations. Slide the drain line off its connector. Set the hose clamp to the side. 4 Look beneath the front door for the screws holding the service panel to the bottom front of the dishwasher. Remove the screws to release the panel and set the service panel aside.
Where is the drain loop on a dishwasher?
The loop should be installed as close as possible to the underside of the cabinet for maximum effectiveness. It is recommended that the discharge end of the drain hose is attached to the vertical sink drain pipe right before the P-trap (never on or after the P-trap).
What are the installation instructions for a dishwasher?
You need to: ■Slowly open dishwasher door while someone grasps the rear of the dishwasher. Remove shipping materials, drain hose and lower rack. Close dishwasher door until latched. ■Observe all governing codes and ordinances. ■Install this dishwasher as specified in these instructions.
How to install drain hose on washing machine?
(Playback ID: HXD0CBEuoXv2f4LY) An error occurred while retrieving sharing information. Please try again later.