Menu Close

Where is the starter located in a Chevy Malibu?

Where is the starter located in a Chevy Malibu?

IF your vehicle is a V-8 the starter is located next to the flywheel on the lower part of the engine on the passenger side. The starter is round about the size of a softball and about 12″ long. It will have a large gage wire going to the starter solonoid.

Where is the starter located in a 2006 Chevy Malibu?

The 2006 Chevy Malibu starter location is at the right front just under the cartridge oil filter housing. The starter is a small motor, powered by the battery. It gets the engine of Your car running.

Where is the starter on a 2005?

The starter is located underneath the engine on the front passenger’s side. On V8 engines, there is a bell cover housing that must first be removed to access the starter. Once this housing is removed, use a 13mm socket with ratchet and extension to remove the two bolts holding the starter in place.

How much is a starter for a 2005 Malibu?

A 2005 Chevy Malibu starter will cost You between $55-$70 for parts. Labor costs are generally around $80-$100 for the replacement.

How much is a starter for a 2005 Camry?

2005 Toyota Camry Starter – from $104.99+ | AutoZone.com.

How to replace the starter on a Chevy Cobalt?

How to replace the starter on a GM 2.2L Ecotec engine in Cobalt, Cavalier, HHR, Malibu and more 1 Remove the large plastic engine cover to get a better view of the position of the upper bolt. Pull the cover free of… 2 Jack up the front of the car. I used a floor jack on the front tubular cross member, with a three foot long two by… More …

How do you replace a starter on a GM Ecotec engine?

5) Break the lower 15mm mounting bolt loose.This is the easy one. The upper bolt will more than make up for it though. 6) Break the upper 15mm mounting bolt loose and then remove. This is the toughie. Use a three or six inch extension bar and a deep well socket fed from underneath.

Where is the oil leaking from the starter?

The leak seems to be coming from a sensor that is threaded into the block under the front exhaust manifold above the starter. I have no idea what sensor this is. There is only one wire going to it and the plug is covered with oil. I unplugged the connector from the sensor and started the car and oil squirts out.