Contents
How do I reset my Pentair ScreenLogic protocol adapter?
Likewise, how do I reset my Pentair protocol adapter? You can use a paper clip to reset the Protocol Adapter by pressing the recessed reset button. You canunplug and plug back in the wireless router to reset it.
What is a Pentair protocol adapter?
The ScreenLogic2 Interface allows you to control the key functions of a pool or spa using the IntelliTouch® and EasyTouch® control systems, through controllers such as an iPad®, iPhone®, iPod touch® mobile digital device, and Mac® computers.
What does searching for system controller mean?
Why does the Configuration program say “Looking for Controller”? If the Configuration program displays “Looking for controller,” for longer then 60 seconds when you start. IntelliTouch ScreenLogic, this may indicate a communication problem somewhere in the system.
How do I access Pentair ScreenLogic remotely?
To connect remotely to your system:
- After installing the “ScreenLogic Connect” utility, click the.
- Enter your ScreenLogic system name in the “System Name”
- In the “Password” box, enter the system password that you.
- Click the “Remember Login info” check box to save your system name and password so that you don’t have.
How do I reset my Pentair?
Simply follow these steps to factory reset your unit:
- Make sure that the pump is on.
- Press the stop button – the pump will stop.
- Press and hold the four buttons simultaneously for about 4 seconds. Power off the unit and restart.
- The factory settings will be in assigned.
How do I connect to Pentair ScreenLogic remotely?
Why does my Rachio keep going offline?
If the controller goes offline during a scheduled run, there may be an issue with the wiring or the irrigation system itself. When zone faults occur, it is often because the controller receives too much electricity from the irrigation system, causing the controller to shut down.
How do I update my Pentair easytouch firmware?
Likewise, people ask, how do I update my Pentair Easytouch firmware? The firmware version can be found on the label on the side of the protocol adapter. Step 1: Update your Protocol Adapter. Close the update tool. Restart the update program. If a second attempt to update fails, then contact Pentair Technical Support for more information.
Why is my Pentair adaptor not updating?
I’m having trouble updating the firmware of a network attached device (Pentair Protocol Adaptor) with my new mesh network. The firmware updating program states that the device needs to be on the same subnet as my PC.
What’s the model number of the Pentair protocol adaptor?
Hence the question about model number. I was lookiing for the hardware specs and User Manual for the device. Probably a more productive effort is to figure out how the device is getting an IP address of 10.0.1.72 If the Orbi DHCP is assigning IP’s in the typical range of 192.168.1.x, the that IP address is not comiing from the Orbi.
Is the Pentair adaptor on the same subnet as my PC?
The firmware updating program states that the device needs to be on the same subnet as my PC. I have the router in the automatic address assigning mode, but the device is assigned an completely different address 10.0.1.72 than my PC 192.168.1.30.