How do you change the batteries in a SimpleHuman soap dispenser?

How to Replace the Batteries on a Simplehuman Soap Dispenser?

Turn the dispenser upside down and locate the battery compartment on the bottom.
Press in on the raised tab to lift off the cover.
Remove the old batteries.
Insert 4 new AA batteries and replace the cover.

Can you refill SimpleHuman soap dispenser?

The cartridge that comes with this unit is not refillable, but you can buy a refillable cartridge separately on the Simplehuman website (not yet available on Amazon).

How do I clean my SimpleHuman soap dispenser?

Unclogging a SimpleHuman Soap Dispenser – 414ml Version

Step 1: Remove the Top.
Step 2: Disconnect Cables and Spout.
Step 3: Remove and Clean Spout.
Step 4: Flush Out the Soap Feed Tube.
Step 5: Remove Chrome Spout Assembly.
Step 6: Remove the Bottom.
Step 7: Remove the Battery Assembly.
Step 8: Clean the Bottom.

How do you open the lever on a soap dispenser?

Open the Dispenser Look underneath the soap dispenser behind the push bar and soap nozzle. You will see a small lever or bar near the wall on the bottom of the dispenser. Push this lever while gently pulling the top of the dispenser toward you. The top should swing away from the wall and hang down.

Why did my SimpleHuman soap dispenser stopped working?

Sensor pump may be clogged. Completely cover the sensor window and tap the power button quickly 3 times (within 2 seconds). Note that this will make the pump run continuously until the sensor window is uncovered. Watch our video on how to unclog your pump.

Why is my SimpleHuman rechargeable soap dispenser not working?

If your rechargeable liquid sensor pump is not working let’s proceed with a quick reset to resolve the issue: Press and hold the power button down for 5 seconds. Wipe the sensor lens clean. We recommend using rubbing alcohol and a micro fiber cloth to do so.

Can you use Dawn dish soap in simplehuman soap dispenser?

Simplehuman Sensor Soap Pump will work with most dish and hand soaps as long as they do not dispense in a foam. I have used mine with Dawn dish soap as well as Softsoap hand soap.

Why is my simplehuman soap dispenser not working?

How to troubleshoot a simplehuman soap dispenser troubleshooting?

Remove the bottom of the soap dispenser. Unscrew the screws that hold the pump to the assembly and unhook the pump from the plastic tube. Remove the screws holding the electronic board and base for easier access to the pump tube. Clean out the tube to remove any hardened soap that is clogging the tube.

Can you use regular soap in a foaming soap dispenser?

However, for foaming dispensers regular liquid hand soap may not work because it is too thick. Also, avoid using soaps with gritty substances like exfoliants and beads. Twist the top plastic cap counterclockwise. Then pour in liquid soap until it reaches the top of the reservoir.

Why is my soap dispenser light not working?

If the light on your soap dispenser flashes when you press the buttons, but you don’t hear the pump motor working, you may have a problem with your sensor. Start by wiping the sensor with a damp cloth, then drying it.

Why is my soap dispenser blue instead of red?

You may have to order a new battery case cover if yours is badly corroded. On pre-2010 models, this light will be blue instead of red. A Simplehuman dispenser that releases soap on its own may have a sensor issue. Start by cleaning the sensor, then check to make sure nothing under the dispenser, such as a shelf, is activating the sensor.