Menu Close

How much does it cost to have a garage door spring install?

How much does it cost to have a garage door spring install?

Garage Door Spring Replacement Cost. Replacing garage door springs costs $150 to $350 on average. The springs alone typically run $30 to $75 each but you may find them as low as $15 a piece and up to $100 each. Commercial grade springs can run $300 or more.

How many twists do I need for a garage door spring?

A rule of thumb with springs is that four quarter turns equals a full revolution and the spring needs to be tightened a full revolution for every foot of door height (e.g. 7-1/2 foot door = 7 revolutions +2 (30 quarter turns).

Can I open my garage door with a broken spring?

As professionals in the industry, we advise you do not attempt to open your garage door if the spring is broken. Extension springs on either side of the door, along the rails, help counterbalance the weight of the door as it is raised or lowered. Torsion springs across the top of the door help do the heavy lifting.

Why are garage door springs so dangerous?

Garage door springs can be dangerous. The danger lies in what happens if and when the springs suddenly fail. Since the spring is under constant tension, a sudden failure can cause the spring to break apart violently.

How do I make my torsion spring stronger?

Maybe make the outer diameter smaller to make it stronger but also add a coil or two to release stress. You may also make the wire diameter larger to a point where it is stronger than you need but then make the outer diameter a bit larger to release tension and also achieve more travel.

Where do you place the spring on a garage door?

Slide the spring that you placed on the left side of the door at the beginning onto the shaft as shown. The stationary cone must be toward the center of the garage door while the winding cone must be toward the outside of the door. 21. You may need to loosen the set screws for the spring to slide onto the shaft. 22.

How to get rid of torsion springs on a garage door?

1. Always wear safety glasses. 2. Unplug garage door opener. 3. Disengage opener from the door. 4. Always stay out of the path of the winding bars and winding cone to prevent possible injury or death. 1. A Pair of 1/2″ winding bars, taped at 1″ from the ends 2. A sturdy step ladder 3. A couple of vice grips 4.

What kind of wrench do I need to replace a garage door spring?

A 7/16” and 9/16” wrench are the only two sizes needed as well as a couple pairs of vice grips and a step ladder. Equipment that is mandatory though are winding bars, which help control the torsion as the spring is being installed and removed.

How big of a hole do you need for a garage door spring?

The rods or bars should be 18 to 24 inches (45.7 to 61 cm) in length. Solid steel bars can be purchased at hardware stores. You will need to measure the diameter of the holes in the winding cone (the collar that secures the spring to the metal shaft) to determine what size bar or rod to use. Most cones have a hole diameter of 1/2 inch.